User Tools

Site Tools


electronics_at_component_level

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
electronics_at_component_level [2018/09/15 09:48]
c0rn3j [IR]
electronics_at_component_level [2018/10/23 08:49] (current)
c0rn3j [How to not ruin a tip]
Line 10: Line 10:
 Do not leave the iron on when you are not using it. Do not leave the iron on when you are not using it.
  
-Clean the tip by applying solder, wiping it clean on a sponge or steel wool and then coat it with a thin layer of solder to prevent oxidation before you turn it off and leave it.+Clean the tip by applying solder, wiping it clean on a sponge or steel wool and then coat it with a thin layer of solder to prevent oxidation before you turn it off and leave it, or coat it right after turning it off.
  
 If you use a sponge, make sure it's damp but not soaked. If you use a sponge, make sure it's damp but not soaked.
electronics_at_component_level.txt ยท Last modified: 2018/10/23 08:49 by c0rn3j